Covox Speech Thing

From Vero - Wikipedia
Jump to navigation Jump to search

Template:Short description Template:Use mdy dates Template:Infobox Computer Hardware Generic

The Covox Speech Thing is an external digital-to-analog converter (DAC) that plugs into the parallel printer port of a PC. It converts 8-bit digital sound using a simple R-2R resistor ladder into an analog signal output.

The Speech Thing was introduced on December 18, 1987<ref>Template:Cite web</ref> by Covox, Inc. of Eugene, Oregon, for about US$70<ref>Template:Cite web</ref> (Template:Inflation) and priced US$79.95 as of 1989.<ref>Template:Cite journal</ref> People soon started to build their own (DIY) variants, since its communication protocol and DAC is simple and only requires soldering a few cheap parts. The novelty of its patent "Parallel port pass-through digital to analog converter" (filed in 1987, granted in 1989)<ref>Template:Cite patent</ref> was not specifically the use of a resistor ladder as a DAC, but rather the patent's discussion is around its ease of plugging into the parallel port and how its resistor ladder design didn't block other devices from using the parallel port. Template:Clarify span as sound cards were still very expensive at that time. The plug was also quite popular in the demoscene.

An inherent problem of the design is that its quality relies on how precisely matched the resistors are (see Template:Slink). If unmatched resistors are used, the resulting voltage levels get shuffled, especially for quiet sounds, resulting in distortion. Nevertheless, the sound quality of the Covox plug is far superior compared to the PC speaker; for some time, a self-built variant was an inexpensive way to give old computers sound capabilities.<ref>Template:Cite book</ref>

Features

File:Covox-Stecker.svg
One widely used variant

The Covox plug received an 8-bit digital byte for each digital audio sample from the parallel port and produced a high impedance mono analog output voltage signal though a mini phone connector. That signal could then be amplified and played back on loudspeakers.

The resistances of the R-2R ladder (100 kΩ and 200 kΩ according to the patent) are deliberately high-enough to prevent excessive loading of the signals, so a printer attached to the output connector will operate normally.

The original Covox plug itself does not use sequential logic or a clock signal, so theoretically it can operate with any sampling rate. In practice, however, parallel port speed limits make it rather hard to achieve even standard 44100 Hz (the average 1980s 80286 system could handle sampling rates of 12 kHz, while later the faster 33 MHz 486SX introduced in 1991 could handle 44 kHz).

Its 15 kΩ load resistor in parallel with a 5 nF capacitor after the R2R resistor ladder results in a passive RC low-pass filter starting around 3 kHz, thus limiting the analog bandwidth. Many DIY variants do not use the same ladder topology and component values, resulting in different timbre.<ref>Template:Cite web</ref>

Another limiting factor was that the CPU had to be interrupted at the sampling rate to play background audio (thus incurring the cost of a context switch for every sample, many thousands of times a second), since there was no data buffering or direct memory access available.

The sound quality can be increased by software through dithering, which reduces perceptible aliasing noise and increases dynamic range (used in Inertia Player and FastTracker 2 as an interpolating option).

Commercial products

  • Covox Speech Thing – a R-2R resistor DAC with parallel port pass through, bundled with speech synthesis software, marketed originally as part of voice synthesis and recognition system.<ref>Template:Cite book</ref>
  • Disney Sound Source – a different design to the Covox Speech Thing, though in a superficially similar case also with parallel pass through, marketed by Disney Software in early 1990s.
    • Consists of a FIFO buffer with a DAC on the board that plugs into the parallel printer port, which transmits analog audio over a registered jack to a separate amplifier / speaker box.<ref>Template:Cite web</ref> Its price was set to only $14<ref>Template:Cite web</ref> and it was supported by many games (see below). It used external power (9 volt battery) and could be turned on/off by software. Contrary to the Covox Speech Thing which had no FIFO buffer, the Disney Sound Source features a 16-byte FIFO allowing for autodetection and flow control, which clocks digital output to the resistive DAC at a fixed sample rate of 7 kHz ±5%.<ref>Template:Cite web</ref>
    • The printed circuit board DSS007C shows "Ⓟ (1983) U.S. 4,384,170 and others"<ref>Template:Cite web</ref> which is an earlier patent by Forrest S. Mozer.<ref>Template:Cite patent</ref> The board a has one integrated circuit only (labeled "ICS1453") and the schematic<ref>Template:Cite book</ref> shows 8 lines from the parallel port going into one chip with input pins D0-D8 that also has a "DAC output" pin going to an output "sound". So it can be inferred that that single chip implements both the FIFO and DAC internally, which differs dramatically from the passive R-2R design of the original Covox.
    • In 2015 the hardware was reverse engineered so compatible circuits can be built from easily available off the shelf components.<ref name="vogons">Template:Cite web</ref> It is also emulated by the popular DOSBox emulator.

Compatibility

File:Custom Covox.jpg
Home-built variant

Games

The Covox plug was not compatible with any of the popular cards of that age (AdLib, Sound Blaster, Gravis UltraSound, etc.), but several games / platforms supported it natively. It is also usually used in tandem with an AdLib sound card as said card officially was a music card and while it could be put into a mode to handle sampled audio, it could not play sampled audio and music at the same time. Notable entries include:

Music trackers

Popular DOS-based trackers used in the demoscene included Covox support, for example:

  • Modplay (also ModEdit, DMP, VP and other Mod players from early 1990s) (Up to 4 channel COVOX output or custom assembler routine for user device)
  • Inertia Player (mono, stereo-on-1 covox, with dithering option).
  • Multiplayer by DGS Italian Software Company
  • Galaxy Music Player (can play MODs even on an Intel 8088)
  • Scream Tracker version 2.3 direct support. Version 3.21 through virtual-soundblaster driver.
  • FastTracker (mono, stereo, stereo-on-1 mode, with dithering).
  • Impulse Tracker

Emulating other sound cards

Emulators exist that allow a physical Covox to appear as if it is another sound card:

  • Virtual SoundBlaster – can emulate Sound Blaster on Covox
  • Covoxer – can emulate Tandy 1000/2000 music synthesizer
  • TEMU – can emulate Tandy 1000/2000 music synthesizer and Disney Sound Source

Emulating Covox

The DOSBox and Fake86 emulators can emulate a virtual Covox (as Disney Sound Source) on machines without a physical Covox.<ref>Template:Cite web</ref>

Operating systems

Several operating systems have an installable driver for Covox:

Later variants

Other Covox products

{{#invoke:Labelled list hatnote|labelledList|Main article|Main articles|Main page|Main pages}}

Also as described in a 1991 COVOX Company Profile:<ref>Template:Cite newsgroup</ref>

  • Covox Sound Master – 1984 for Apple II, 1989 for MS-DOS
  • Covox Voice Master System II – 1990
  • Covox MIDI Maestro – 1990
  • Covox Sound Master II – 1990

References

Template:Reflist

Template:Commons category

Template:PC sound standards

Retrieved from "https://wiki.sarg.dev/index.php?title=Covox_Speech_Thing&oldid=689259"